Free standing mailboxes residential – Check guidelines US Postal Service before building your mailbox. Contact your local post office before you move your mailbox. Second, build a mailbox stand of treated 4-by-4 lumber. Cut a board 57 inches long. Cut another 36 inches long. Third, measure your mailbox. Allow an extra inch of clearance and mark the 36-inch board accordingly. Fourth, cut between the two selected lines to a depth of the first 75 inches (half the width of a 4-by-4). Remove waste with more cuts from a chain saw or with a hand chisel and hammer.
Measure 57- inch board. Make it 41 inches and over 44.5 inches. Remove wood in between the marks to a depth of 1.75 inches. Sixth, dry suits the two boards together. Far more wood as necessary until the boards fit together snugly. When fit, glue them together with outdoor-grade wood glue. Let dry. Seventh, measure the underside of your mailbox. Cut a 1- tamer- thick board so that it fits just inside the free standing mailboxes residential bottom. Unscrew the plate and the 4-by-4’s mailbox support arm.
Set mailbox on 1- inch board and screw the mailbox to the board through the holes in the side of the mailbox. Obtain a 5-gallon bucket or antique milk can. Drill little holes in the bottom so water can drain out. The holes should be smaller than the gravel to be used for filling. Nineth, place the mailbox position in the middle of the bucket. Pour into fine gravel until the bucket or can is almost full. You can replace the potting soil of gravel, and then plant flowers inside. Last, place the free standing mailboxes residential the required distance from the road or curb.