Laminate trimmer router – The standard base on the laminate trimmer, you can use the beading, straight, creeks, V-groove and round the pieces for different types of jobs. Besides laminate trimmer router edges, the standard trimmer base used to make hinges insertion of a door. After layout hinges for a cabinet or door, use the default base trimmer to remove the wood to make the depression in the wood, which means that you can drop the hinge of the wood so it is flush.
Under scribe Base
The under scribe base Trimmer makes precise cuts in the joints. The guide lip holding the trimmer in place of the trimmer slide along the installed laminate trimmer router. The piece makes cut for laminate mating to form the seamless butt joint. Generally, a joint of this type is used when you make a face frame.
Offset base trimmers used for trimming narrow edges of the laminate trimmer router and trim corners in a backsplash. When using this base you can get within 3/4 inches of a corner or wall. The base is triangular, with the piece on the front of the base. The tip of the triangular base fits right into a corner to make smooth cuts in laminate.
Tilt-base trimmer, you can trim the corners as standard trimmer bases cannot reach. Hand trimming laminate eliminated when using the tilt-base trimmer as it can be adjusted for the 90- and 45-degree angle. The base allows the piece to be flush with the laminate edge for a clean cut. When using the tilt-base, you can change how little trim the laminate for a different profile on the laminate edge.