Build a wooden magazine rack end table for your home can be completed in an afternoon. The project requires adequate supplies, and it can be cheap, if you already have the tools. Magazine rack, which is described in this article, is designed to hang on the wall. After it is built, you can paint or stain the shelves to fit every room. Cut back on one side of each piece of wood at an angle, as the top of the wood will be wider at the base. Put back the Board flat on the work surface so that one side of 10-inch towards you.
Spread wood glue on the edge of one of the 10-inch strips of wood. Press edge glued to the top of the Board so that the edge of the wood strip back to the edges of the bottom of the Board. The belt must stand at right angles to the motherboard again. Strap attached will be at the bottom of the magazine rack end table. Shoot the nails through the rear part of the backrest back on the edge of the 2-inch tape.
Attach the belt on the front of the magazine rack end table hammering nails complete two at both ends of the Board. Use a small nail, so edits will look like. Two 2-inch finishing nails, attach the belt with 1 inch above the first line. The last stapled 2-inch finishing nail belt with 1 inch above the second row. When you are finished, the bottom Strip must be lined up the bottom shelf, the upper Strip must be lined up with the top of the side walls, and each strip should be 1 inch apart.